Re: insight/328: Remote debugging - register window does not get updated after download

classic Classic list List threaded Threaded
1 message Options
Reply | Threaded
Open this post in threaded view
|

Re: insight/328: Remote debugging - register window does not get updated after download

Robert Bu 卜勇华
The following reply was made to PR insight/328; it has been noted by GNATS.

From: Robert Bu <[hidden email]>
To: <[hidden email]>
Cc:  
Subject: Re: insight/328: Remote debugging - register window does not get
 updated after download
Date: Mon, 16 Nov 2009 20:14:49 +0800

 Hi,
 
 I have the same problem here (insight 6.8-1). I can see the updated
 registers if I select another group, such as "system". However, the
 register remain as read-only. They become editable only after I run some
 instructions. And if I connect to remote target first, then open the
 register window, all works right.
 
 I think it can be reproduced by gdbserver. If I open the register window
 first, then connect to the remote target (through "target remote xxx" in
 console window), the register shown in insight's register window is
 read-only. However, if I connect to the remote target first, then open
 the register window, all seems OK. And in the former problematic
 situation, if I close the register windown, then open it again, it's
 also OK. Maybe, there's some event missing for the register window.
 
 --
 
 Best regards.
 Robert